Agilent HP 8904A Multifunction Synthesizer, DC-600 KHz
The standard Agilent Technologies 8904A multifunction synthesizer generates
accurate sinewaves from 0 Hz to 600 kHz with 0.1 Hz resolution. The 8904A
also has five other standard functions: square, triangle, ramp, from 0
Hz to 50 kHz plus dc, and Gaussian white noise. All waveform values in
the 8904A are digitally calculated in real time by Agilent Technologies'
Digital Waveform Synthesis IC yielding 12-bit digital accuracy. Full GPIB
programmability is also included standard on the 8904A.
Features:
- Sine to 600 kHz, square, ramp, triangle to 50 kHz
- 12 bit direct digital synthesis
- Tone, DTMF, digital, Hop Ram sequence modes
- One or two outputs
- One to four internal channels
- AM, FM, Phi-M, DSBSC, and pulse modulation
- Unit to unit phase synchronization
Specifications:
(For 50 ohm output only)
Frequency
Range: Sinewave: 0 Hz to 600 kHz Square, triangle,
ramp: 0 Hz to 50 kHz Resolution: 0.1 Hz Accuracy: (internal
10 MHz timebase): 50 ppm
AC Amplitude (sinewave only)
Range: 0 to 10 V p-p into a 50 ohm load Accuracy:
(>40 mV p-p into 50 ohms): 1%, 0.1 Hz to 100 kHz; 3%, 100 kHz to 600
kHz Flatness: (>630 mV p-p into 50 ohms):+/- 0.1% (+/- 0.009
dB), 0.1 Hz to 100 kHz
DC Amplitude
Range: 0 to +/- 10 V p-p open circuit Accuracy:
Larger of +/- 20 mV or +/- 2.1%
Spectral Purity (sinewave only)
THD + N(including spurs, amplitude > 50 mV
rms into 50 ohms): -63 dBc rms (0.07%), 20 Hz to 7.5 kHz, 30 kHz BW -63
dBc rms (0.07%), 7.5 kHz to 20 kHz, 80 kHz BW
Gaussian Noise
Spectral Characteristic:Equal energy per unit
bandwidth ("white") Time Domain Characteristic:Gaussian distribution
Flatness(>100 mV p-p): Typically +/- 0.5 dB, 0.1 Hz to 100 kHz
Ordering Information:
Agilent HP 8904A Multifunction Synthesizer, DC-600 KHz
| Agilent 8904A |
Function Synthesizer DC-600 KHz |
| Opt 001 |
Adds three (two when ordered with Opt 002) internal
channels,Channel A modulation, summation, FM stereo mode, and sequence
capability |
| Opt 002 |
Adds second internal synthesizer and output |
| Opt 003 |
Adds fast hop and digital modulation |
| Opt 004 |
Connectors on rear panel only (not available with Opt
005 or 006) |
| Opt 005 |
Adds unit to unit phase synchronization |
| Opt 006 |
Changes output #1 from a 50 ohm output to a transformer
coupled,600 ohm balanced output |
| Opt 8ZE |
Refurbished equipment |
| Opt 910 |
Provides an additional operation and calibration manual
(08904-90007) and two service manuals (08904-90008) |
| Opt 915 |
Adds Service Manuals (08904-90008) |
|
MetricTest
Solutions
